Asko refrigerator
showing F2
F2 points at the condenser fan, the one that keeps air moving over the part where the appliance sheds the heat it has pulled out of the cabinet.
Mon–Sat, 8am–8pm
- Fan circuit
- Fan and airflow repair
- Source: ASKO
Book a visit
Three short steps, about a minute.
or call (844) 681-4650
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F2
actually means.
F2 points at the condenser fan, the one that keeps air moving over the part where the appliance sheds the heat it has pulled out of the cabinet. When it stops, Asko says the appliance cannot operate normally, so this is a stop-and-empty code.
ASKO refrigerator display
What to do when F2 shows on the refrigeratorKind of codeFan circuit
A fan the control board expected to be turning is not — a motor that has failed, or ice holding the blade still.
Usually leads toFan and airflow repair
Two fans, two completely different failures — one stops the cold arriving, the other stops the heat leaving.
Shows up asRefrigerator Not Cooling
The compartment is warm but the appliance still has power and still makes noise.
MakeASKO
Scandinavian integrated refrigeration, mostly behind furniture panels.
SourceAsko Instructions for use, models RBR276SND1 / RBR2764DND1 / RBR2767DND1 / RBR276DND1, troubleshooting table (PDF on the Gorenje Group document server)
Asko RBR276SND1, RBR2764DND1, RBR2767DND1 and RBR276DND1 (one Instructions for use covers all four). F2 is not listed in the R31442I manual.
Before you book,
in this order.
Each step comes from ASKO's own guidance for F2 on its refrigerators. Follow it to the end: the last card says whether this is a visit.
Take the food out and put it somewhere cool before it starts to warm.
Turn the appliance off, as Asko's manual directs for F2.
Book a visit; the condenser fan needs a technician before the unit runs again.
What not to do
F2 does not refer to the fan inside the compartment, which reports as F1. This code is about the fan at the condenser.
What you may
notice with it.
The refrigerator problems F2 tends to arrive with. Answer these at the refrigerator before anyone is booked.
All problems
Refrigerator Not Cooling
7 causes, cheapest first
Where F2 usually leads
Fan and airflow repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesASKO
refrigerators.
Scandinavian integrated refrigeration, mostly behind furniture panels.
ASKO refrigerator repair
Built-in refrigerator
Flush with the cabinets, serviced from the front, and almost always repaired rather than replaced.
Refrigerator column
Separate refrigerator and freezer towers, each with its own sealed system — so a failure stays on one side.
Undercounter refrigerator
A single 15 to 24 inch unit under the worktop — front-vented, tightly enclosed, and easily starved of air.
In ASKO's own words
The display shows error code F2. The condenser fan is malfunctioning.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Asko RBR276SND1, RBR2764DND1, RBR2767DND1 and RBR276DND1 (one Instructions for use covers all four). F2 is not listed in the R31442I manual.
ASKO F2 refrigerator repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F2.
Can I clear F2 myself?
What does the condenser fan behind F2 do on my Asko?
Should I keep my Asko switched on with F2 showing?
Back to your everyday
Still showing F2?
Book with the exact characters, the full model number, and whether it is still cooling — on a code, that is the whole starting point.