Asko refrigerator
showing F1
F1 means the fan that moves cold air through the cooling compartment is malfunctioning.
Mon–Sat, 8am–8pm
- Fan circuit
- Fan and airflow repair
- Source: ASKO
Book a visit
Three short steps, about a minute.
or call (844) 681-4650
Loading appointment form…
The appointment form couldn’t load. Please try again.
What F1
actually means.
F1 means the fan that moves cold air through the cooling compartment is malfunctioning. Unlike the sensor codes, there is no safe mode to fall back on: Asko says the appliance cannot operate normally.
ASKO refrigerator display
What to do when F1 shows on the refrigeratorKind of codeFan circuit
A fan the control board expected to be turning is not — a motor that has failed, or ice holding the blade still.
Usually leads toFan and airflow repair
Two fans, two completely different failures — one stops the cold arriving, the other stops the heat leaving.
Shows up asRefrigerator Not Cooling
The compartment is warm but the appliance still has power and still makes noise.
MakeASKO
Scandinavian integrated refrigeration, mostly behind furniture panels.
SourceAsko Instructions for use, models RBR276SND1 / RBR2764DND1 / RBR2767DND1 / RBR276DND1, troubleshooting table (PDF on the Gorenje Group document server)
Asko RBR276SND1, RBR2764DND1, RBR2767DND1 and RBR276DND1 (one Instructions for use covers all four). On the RFN23841 and R23841 a fan problem shows as a flashing light rather than letters.
Before you book,
in this order.
Each step comes from ASKO's own guidance for F1 on its refrigerators. Follow it to the end: the last card says whether this is a visit.
Move the food somewhere cold, such as another refrigerator or a cooler with ice, as the manual instructs.
Switch the appliance off once it is empty.
Book a visit for the compartment fan and leave the unit off until then.
What not to do
F1 is not a message you can wait out. Without that fan the compartment cannot hold its temperature, which is why the manual says to empty the unit and turn it off.
What you may
notice with it.
The refrigerator problem F1 tends to arrive with. Answer these at the refrigerator before anyone is booked.
All problems
Where F1 usually leads
Fan and airflow repair.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesASKO
refrigerators.
Scandinavian integrated refrigeration, mostly behind furniture panels.
ASKO refrigerator repair
Built-in refrigerator
Flush with the cabinets, serviced from the front, and almost always repaired rather than replaced.
Refrigerator column
Separate refrigerator and freezer towers, each with its own sealed system — so a failure stays on one side.
Undercounter refrigerator
A single 15 to 24 inch unit under the worktop — front-vented, tightly enclosed, and easily starved of air.
In ASKO's own words
The display shows error code F1. The cooling compartment fan is malfunctioning.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Asko RBR276SND1, RBR2764DND1, RBR2767DND1 and RBR276DND1 (one Instructions for use covers all four). On the RFN23841 and R23841 a fan problem shows as a flashing light rather than letters.
ASKO F1 refrigerator repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about F1.
Can I clear F1 myself?
Can I leave my Asko running while F1 is on the display?
Which fan does F1 refer to on an Asko RBR276?
Back to your everyday
Still showing F1?
Book with the exact characters, the full model number, and whether it is still cooling — on a code, that is the whole starting point.