The back wall inside the fresh food compartment of a refrigerator, a small temperature sensor clipped beside the air vents, shelves soft in front of it.

Miele refrigerator
showing F114

F114 points to the freezer section's evaporator sensor.

(844) 681-4650

Mon–Sat, 8am–8pm

  • Sensor circuit
  • Controls and sensors
  • Source: Miele

Book a visit

Three short steps, about a minute.

or call (844) 681-4650

Before you book,
in this order.

Each step comes from Miele's own guidance for F114 on its refrigerators. Follow it to the end: the last card says whether this is a visit.

01

Note the code and the model number.

02

Check the freezer temperature so you can tell the service desk how it is holding.

03

Book a repair appointment with Miele Service.

Still there?

It usually turns into controls and sensors. Book with the code and the model number.

What not to do

It is not the fresh food sensor, and it is not a general F0 to F5 code. Miele names the freezer evaporator sensor specifically.

What you may
notice with it.

The refrigerator problems F114 tends to arrive with. Answer these at the refrigerator before anyone is booked.

All problems

Where F114 usually leads

Controls and sensors.

Control board · moderate.

In Miele's own words

The freezer section evaporator sensor is faulty. This is a technical fault that you cannot remedy yourself.
Miele USA support: F114 (Wayback Machine copy of mieleusa.com, January 2026; the live page refuses automated reads)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing.

Miele F114 refrigerator repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A family preparing a meal together in their kitchen
For the heart of your home.

Questions
about F114.

Can I clear F114 myself?
Note the code and the model number. If it comes back, it needs a visit.
Is my Miele freezer about to stop working because of F114?
F114 names the freezer section's evaporator sensor as defective. Miele does not frame it as a cooling failure, but the sensor cannot be fixed by the owner. Checking the actual freezer temperature tells you how much time you have.
Can a reset clear F114 on a Miele?
Miele describes it as a technical issue the owner cannot remedy, so a repair appointment is the route. Note the code and model number first. The fresh food sensor and the general F0 to F5 codes are different messages.

Back to your everyday

Still showing F114?

Book with the exact characters, the full model number, and whether it is still cooling — on a code, that is the whole starting point.

(844) 681-4650 Schedule a repair