

Thermador refrigerator
showing Water Filter Symbol flashing
A flashing water filter symbol is a reminder that the filter is old and needs replacing.
Mon–Sat, 8am–8pm
- Mode, not a failure
- No repair needed
- Source: Thermador
Book a visit
Three short steps, about a minute.
or call (844) 681-4650
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Water Filter Symbol flashing
actually means.
A flashing water filter symbol is a reminder that the filter is old and needs replacing. It can keep flashing after you fit a new filter if the filter is not seated all the way, or if the new filter has not been activated on the panel. Nothing has broken.
Thermador refrigerator display · also shown as Water filter symbol flashing
What to do when Water Filter Symbol flashing shows on the refrigeratorKind of codeMode, not a failure
A setting somebody chose, or an alert it raised on purpose — a showroom mode, a door or power alarm. Nothing has broken and no part is needed.
Usually leads toNo repair
Replace the filter if it is due.
Shows up asRefrigerator Not Cooling
The compartment is warm but the appliance still has power and still makes noise.
MakeThermador
Built-in columns and panel-ready refrigeration designed around the cabinet run.
SourceThermador US support: refrigeration troubleshooting, "The Water Filter Symbol Is Flashing"
The reset buttons vary by model. Thermador names LIGHT / FILTER or SUPER COOL together with ICE for certain models.
Before you book,
in this order.
Each step comes from Thermador's own guidance for Water Filter Symbol flashing on its refrigerators. Follow it to the end: the last card says whether this is a visit.
Replace the filter if it is due.
If you just replaced it, check that it is turned all the way in and the lines on the cap line up with the lines on the compartment.
On some models, hold LIGHT / FILTER or SUPER COOL together with ICE for 3 seconds to activate the new filter.
Check your owner's manual for the button combination on your model.
Cleared?
Nothing needed repairing. If the refrigerator does not settle back to temperature, that is a separate problem.
What not to do
It is not a cooling or water valve problem. The symbol is only asking for a new filter, or for a new one to be activated.
What you may
notice with it.
The refrigerator problems Water Filter Symbol flashing tends to arrive with. Answer these at the refrigerator before anyone is booked.
All problems
Refrigerator Not Cooling
7 causes, cheapest first
No repair indicated
Nothing to repair.
A setting somebody chose, or an alert it raised on purpose — a showroom mode, a door or power alarm. Nothing has broken and no part is needed.
Read these
before the visit.
Short guides that make the call quicker and the diagnosis cheaper.
All guidesThermador
refrigerators.
Built-in columns and panel-ready refrigeration designed around the cabinet run.
Thermador refrigerator repairMode, not a failure on other makes
All 83 codes of this kind
Built-in refrigerator
Flush with the cabinets, serviced from the front, and almost always repaired rather than replaced.
Refrigerator column
Separate refrigerator and freezer towers, each with its own sealed system — so a failure stays on one side.
French door refrigerator
Two fresh-food doors over a freezer drawer — the most common premium layout, and the one with the most to go wrong at the door line.
In Thermador's own words
The water filter is old and needs to be replaced.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. The reset buttons vary by model. Thermador names LIGHT / FILTER or SUPER COOL together with ICE for certain models.
Thermador Water Filter Symbol flashing refrigerator repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Water Filter Symbol flashing.
Can I clear Water Filter Symbol flashing myself?
Why is my Thermador water filter symbol still flashing after I put in a new filter?
Does a flashing filter symbol on a Thermador mean something is wrong with the water valve?
Back to your everyday
Still showing Water Filter Symbol flashing?
Book with the exact characters, the full model number, and whether it is still cooling — on a code, that is the whole starting point.